Using of 3D Printing Technology in Low Cost Prosthetics

Using of 3D Printing Technology in Low Cost Prosthetics
复制标题

3D 打印技术在低成本假肢中的应用

DOI：
--
复制
发表时间：
2018
期刊：
影响因子：
--
通讯作者：
M. Ackermann
M. Ackermann
中科院分区：
--
文献类型：
--
作者：
Jan Koprnický;J. Šafka;M. Ackermann

文献摘要

被引文献

相似文献

3D打印技术用于上肢假肢的最终生产是本文的主题。它侧重于不同的3D打印技术和不同热塑性材料的测试。以HACKberry开源肌电仿生手的食指为测试对象.该部件采用不同的打印技术（FFF/FDM、SLA、SLS、PolyJet）和不同的材料（PLA、ABS、PC-ABS、Though等）进行3D打印，and different不同strategies策略（heightof layers层）.对手指进行机械测试，以模拟头端夹持时的屈曲。论文最后总结了本课题的研究和试验结果，并重点介绍了零件生产的最佳材料、工艺和策略。
The 3D printing technology used for final production of upper limb prostheses is the topicof this article. It focuses on different 3D printing technologies and testing of different thermoplasticmaterials. As the testing object an index finger of HACKberry open source myoelectric bionic handwas used. This part was 3D printed by using of different printing technologies (FFF/FDM, SLA, SLS,PolyJet), and different materials (PLA, ABS, PC-ABS, Though, etc.), and different strategies (heightof layers). The fingers were mechanically tested to simulate flexion in a tip pinch grip. At the endof this paper results of this research and testing is summarized, and optimal material, technology andstrategies of parts production is highlighted.