Development of ITER-CS model coil terminal assembling by using indium wires
Development of ITER-CS model coil terminal assembling by using indium wires
复制标题
ITER-CS型铟丝线圈端子组装的开发
DOI：
10.1016/s0920-3796(01)00289-7
复制
发表时间：
2001
期刊：
影响因子：
--
通讯作者：
H. Tsuji
中科院分区：
文献类型：
--
作者：
Y. Takahashi;T. Kato;Y. Nunoya;T. Ando;G. Nishijima;H. Nakajima;T. Hiyama;M. Sugimoto;T. Isono;N. Koizumi;K. Kawano;H. Tsuji
制作了ITER CS模型线圈，并成功地进行了性能测试。开发了铟丝组装技术用于端子接头。制造短样品以建立该技术，并且它们的接头电阻足够低（在4.5 T，50 kA下为1.4n Ω）。将该技术应用于CS模型线圈的七个接头的装配，并成功地完成了装配。在性能测试中已经证实，这些接头的电阻低于5 nΩ。根据这些结果，可以得出结论，所开发的使用铟线的组装技术是适用的和有用的超导线圈与大电流导体的终端接头。
The ITER-CS model coil was fabricated and its performance test was successfully carried out. The assembling technique by using indium wires was developed for the terminal joints. The short samples were fabricated to establish the technique and their joint resistance was low enough (∼4 nΩ at 4.5 T, 50 kA). This technique was applied to the assembling of seven joints in the CS model coils and the assembling was successfully completed. It has been confirmed in the performance test that the resistance of these joints is lower than 5 nΩ. According to these results, it can be concluded that the developed assembling technique by using indium wires is applicable and useful to the terminal joints of superconducting coils with the large-current conductors.