Describing and Evaluating Deviations for Bevel Gear Flanks
Describing and Evaluating Deviations for Bevel Gear Flanks
复制标题
描述和评估锥齿轮齿面的偏差
DOI：
10.1016/j.procir.2016.06.045
复制
发表时间：
2017
期刊：
影响因子：
--
通讯作者：
Julia Mazak
中科院分区：
文献类型：
--
作者：
F. Klocke;C. Brecher;C. Löpenhaus;Julia Mazak
设计锥齿轮的加工工艺是一个相当大的挑战。为了了解和分析锥齿轮的加工过程，并最终预测其对磨损行为的影响，了解切屑的几何形状、形成和特征值是必不可少的。现有的模拟锥齿轮加工的一种方法是基于二维穿透计算，本文的目的是通过推导出的齿面几何来验证该模拟方法。结果得到了经过验证的齿面几何形状，可应用于基于有限元的齿面接触分析。
Designing the cutting process of bevel gears poses a considerable challenge. For understanding as well as analyzing the bevel gear cutting process and eventually predicting the effects on wear behavior, knowledge of the chip geometry, its formation and characteristic values is essential. One existing method for simulating bevel gear cutting is based on a two-dimensional penetration calculation.The objective of this paper is to validate the simulation method by means of the derived flank geometry. As a result, a validated and verified flank geometry is obtained which can be applied to a FE-based tooth contact analysis.