Impregnation of veneer with furfuryl alcohol for an improved plasticization and moulding
Impregnation of veneer with furfuryl alcohol for an improved plasticization and moulding
复制标题
DOI：
10.1007/s00107-013-0677-4
复制
发表时间：
2013-03-01
影响因子：
2.6
通讯作者：
Pfriem, Alexander
中科院分区：
文献类型：
--
作者：
Herold, Nadine;Pfriem, Alexander
由于机械限制，单板在表面上的应用仅限于简单的形状。为了提高成型性能，单板样品用糠醇浸渍以改善塑化。根据埃里克森杯突试验测定糠醇的增塑效果，并将结果与对照样品和水饱和样品进行比较。糠醇的塑化程度与使用水相当，成型路径明显改善，水改善了 71%，糠醇改善了 86%。最大负载几乎没有观察到变化。
Due to mechanical restrictions veneer application on surfaces is limited to simple shapes. To enhance the moulding performance veneer samples were impregnated with furfuryl alcohol for improved plasticization. The plasticizing effect of furfuryl alcohol was determined according to the Erichsen cupping test and results were compared to control samples and water saturated samples. The extent of furfuryl alcohol plasticization is comparable to the use of water with the shaping path being distinctly improved by 71 % for water and 86 % for furfuryl alcohol. Little changes were observed for maximum load.