The Tribological Behaviors of Different Mass Ratio Al2O3-TiO2 Coatings in Water Lubrication Sliding against Si3N4
The Tribological Behaviors of Different Mass Ratio Al2O3-TiO2 Coatings in Water Lubrication Sliding against Si3N4
复制标题
DOI:
10.1080/10402004.2015.1079348
复制
发表时间:
2016-03
影响因子:
2.1
通讯作者:
Defa Wu;Yinshui Liu;Xufeng Zhao;Donglin Li;Xiaojun Ren
中科院分区:
文献类型:
--
作者:
Defa Wu;Yinshui Liu;Xufeng Zhao;Donglin Li;Xiaojun Ren
ABSTRACT The tribopairs of water hydraulic plunger pumps are usually operated under severe conditions, due to the poor lubrication of water and silt suspended in natural water. It is essential to identify the desired engineering materials and material combinations for designing water pumps. As the candidate materials of tribopairs, the tribological characteristics of different Al2O3-TiO2 coatings combined with Si3N4 ceramics under silt-laden water and tap water lubrication were investigated. The Al2O3-TiO2 coatings with different weight percentages of TiO2 in a wide range from 3 to 100% were tested. The tribological characteristics of the various couple pairs were researched using a ring-on-ring test rig. The microstructures of the contact surfaces were analyzed with a scanning electron microscope before and after the test to study the wear mechanism. The experimental results indicate that the friction coefficient of the Al2O3-TiO2/Si3N4 tribopairs increases with an increase in the percentage of TiO2 content in the Al2O3-TiO2 coating. However, the TiO2 content does not present a clear relationship with the wear rate. Considering the friction and wear properties, Al2O3-13%TiO2 is the preferred coating to use in water hydraulic pumps when sliding against Si3N4.