Coloring Method for Titanium Alloy by Using EDM Process

Coloring Method for Titanium Alloy by Using EDM Process
复制标题

钛合金电火花加工着色方法

DOI：
10.2526/jseme.32.70_32
复制
发表时间：
1998
期刊：
影响因子：
--
通讯作者：
H. Hagino
H. Hagino
中科院分区：
--
文献类型：
--
作者：
H. Minami;K. Masui;H. Tukahara;H. Hagino

文献摘要

被引文献

相似文献

提出了一种新的钛合金电火花着色方法。采用这种方法，在电介质水中进行电火花线切割加工时，无需任何其他后处理，即可获得所需的有色表面。本文讨论了钛合金的变色机理及工艺条件对色调的影响。得到的结果如下：(1)在电解作用下形成的阳极氧化膜中的干涉现象直接给放电过程中形成的熔融溶解表面着色。(2)氧化膜的厚度决定了色调，因此可以通过控制平均工作电压来提供各种颜色。
A new coloring method for titanium alloy by using EDM process is proposed. With this method, the requested colored surface is obtained during the finishing Wire-EDM process in a dielectric water without any other post treatment. In this paper, the coloring mechanism for titanium alloy and the influence of the processing condition to the color tone are discussed. The results obtained are as follows: (1) A molten and resolidif ied surface created by electrical discharge process is colored directly by the interference phenomena in the anodic oxide film formed with electrolytic affection. (2) The thickness of the oxide film determines the color tone, so it can be possible to give various kind of colors by controlling the average working voltage.