Novel statistical analysis method for determining shear strength of C/C composite pin

Novel statistical analysis method for determining shear strength of C/C composite pin
复制标题

确定 C/C 复合销剪切强度的统计分析新方法

DOI:
10.1016/j.ceramint.2019.10.275
复制
发表时间:
2020-03
影响因子:
5.2
通讯作者:
Jingwei Yu
Jingwei Yu
中科院分区:
材料科学1区
文献类型:
--
作者:
Fei Guo;Qingguo Fei;Yanbin Li;Peiwei Zhang;Meng Wang;Jingwei Yu

文献摘要

参考文献

被引文献

相似文献

强度的离散性严重制约了C/C复合材料的广泛应用。用统计分析方法研究了C/C复合材料的强度。本文提出了一种新的统计分析方法--B-分布来检验C/C复合材料销钉的剪切强度。该方法是使用贝叶斯推理方案与马尔可夫链蒙特卡罗采样器。然后,利用B分布和四种传统的统计模型(三参数Weibull、二参数Weibull、对数正态和Gamma)计算了C/C复合材料在不同方向上的剪切强度分布。这些是严格分析的Kolmogorov-Smirnov(K-S)检验和最大似然检验。其次,统计分析了加载方向对C/C复合材料钉剪切强度的影响。结果表明,B分布是最适合实验数据的统计分布。另外,C/C复合材料销钉在30°和45°方向的高可靠性剪切强度相对较高,而在75°和90°方向的高可靠性剪切强度相对较低。
The discreteness of strength seriously restricts the wider use of Carbon/Carbon (C/C) composites. The strength of C/C composites is studied by using statistical analysis methods. Here, a novel statistical analysis method named B-distribution is proposed to examine the shear strength of C/C composite pins. The method is implemented using a Bayesian inference scheme with a Markov Chain Monte Carlo sampler. Then, the shear-strength distributions of the C/C composites in different directions are calculated by the B-distribution and four traditional statistical models (three-parameter Weibull, two-parameter Weibull, log-normal, and gamma). These are critically analysed by a Kolmogorov-Smirnov (K–S) test and a maximum likelihood test. Next, the effect of the loading direction on the shear strength of C/C composite pin is statistically analysed. The results show that the B-distribution is the most appropriate statistical distribution for the experimental data. Additionally, it is found that the high reliability shear strengths of C/C composite pin in the 30° and 45° directions are relatively higher, and the high reliability shear strengths of C/C composite pin are relatively lower in the 75° and 90° directions.
DOI: 10.1016/j.ymssp.2011.09.001
发表时间: 2012-02
影响因子: 8.4
作者:
L. Mehrez;A. Doostan;D. Moens;D. Vandepitte
通讯作者: L. Mehrez;A. Doostan;D. Moens;D. Vandepitte
DOI: 10.1016/s0955-2219(99)00087-4
发表时间: 1999-12
影响因子: 5.7
作者:
M. A. Madjoubi;C. Bousbaa;M. Hamidouche;N. Bouaouadja
通讯作者: M. A. Madjoubi;C. Bousbaa;M. Hamidouche;N. Bouaouadja
DOI: 10.1016/j.compscitech.2013.04.018
发表时间: 2013-06-28
影响因子: 9.1
作者:
Liu, Fengrui;Zhao, Libin;Fei, Binjun
通讯作者: Fei, Binjun
DOI: 10.1016/j.ceramint.2007.10.003
发表时间: 2009-01-01
影响因子: 5.2
作者:
Basu, Bikramjit;Tiwari, Devesh;Prasad, Rajesh
通讯作者: Prasad, Rajesh
DOI: 10.1016/j.ceramint.2013.08.093
发表时间: 2014-04
影响因子: 5.2
作者:
Serkan Nohut
通讯作者: Serkan Nohut