Readout chip for Column Parallel CCD, CPR2A
Readout chip for Column Parallel CCD, CPR2A
复制标题
列并行CCD读出芯片，CPR2A
DOI：
10.1016/j.nima.2009.06.026
复制
发表时间：
2009
期刊：
影响因子：
--
通讯作者：
Havranek M
中科院分区：
文献类型：
--
作者：
Havranek M
LCFI协作[LCFI协作主页：http://hepwww.rl.ac.uk/LCFI/]]正在为国际线性对撞机（ILC） [ILC参考设计报告，2007:http://www.linearcollider.org/cms/?pid=1000437]]的顶点检测器（VXD）开发传感器，读数电子和机械支撑结构，以及研究VXD将实现的物理性能。自从VXD [K.D.诺夫,诊断。Instr。和冰毒。569(1)(2006)48-52。]必须提供出色的空间分辨率，传感器必须具有非常低的质量，其功耗必须小，以确保传感器本身尽可能少地引起多次散射，并且可以使用气体冷却在约- 40℃的温度下操作它们。还需要高速读出，以确保由于在ILC对生产背景的占用保持在1%以下的水平。为了满足这些严格的要求，列并行ccd (cpccd) [S]。蠕虫等人，核。Instr。和冰毒。582(3)(2007)839-842。]和列并行读出芯片（CPRs） [Stephen Thomas等人，项目规范CCD列并行读出ASIC (CPR)，版本：5.1 (CPR2A/B/C), 2007；Tim Wooliscroft， CPR2读出专用集成电路的独立测试，2006。http://hepwww.rl.ac.uk/LCFIwww/Detectors/CPR/CPR2TestReport.pdf]已经开发出来。读出芯片必须能够与cpccd同步工作，并确保低噪声和数据压缩的快速信号处理。本文介绍了最新版本的读出芯片CPR2A的设计和性能。
The LCFI Collaboration [LCFI Collaboration homepage: http://hepwww.rl.ac.uk/LCFI/] is developing the sensors, readout electronics and mechanical support structures for the vertex detector (VXD) of the International Linear Collider (ILC) [ILC Reference Design Report, 2007: http://www.linearcollider.org/cms/?pid=1000437], as well as studying the physics performance that the VXD will achieve. Since the VXD [K.D. Stefanov, Nucl. Instr. and Meth. 569(1) (2006) 48–52.] must provide excellent spatial resolution, the sensors must have very low mass and their power consumption must be small to ensure that the sensors themselves cause as little multiple scattering as possible and that gas cooling can be used to operate them at temperatures of about −40C. High-speed readout is also needed to ensure that the occupancy due to the pair production background at the ILC is kept below the 1% level. In order to satisfy these strict requirements, Column Parallel CCDs (CPCCDs) [S. Worm et al., Nucl. Instr. and Meth. 582(3) (2007) 839–842.] and Column Parallel Readout chips (CPRs) [Stephen Thomas et al., Project specification CCD Column Parallel Read-out ASIC (CPR), Version: 5.1 (CPR2A/B/C), 2007; Tim Wooliscroft, Standalone tests of CPR2 readout ASIC, 2006. http://hepwww.rl.ac.uk/LCFIwww/Detectors/CPR/CPR2TestReport.pdf] have been developed. The readout chips must be able to operate synchronously with the CPCCDs and ensure fast signal processing with low noise and data compression. The design and performance of the latest version of the readout chip, the CPR2A, are described here.
DOI：
10.1016/j.nima.2006.09.010
发表时间：
2006-12-10
影响因子：
1.4
作者：
Stefanov, Konstantin D.
通讯作者：
Stefanov, Konstantin D.