陽極酸化 Al-Mg 合金の電解着色後の色調に及ぼす連続ねじり加工の影響
陽極酸化 Al-Mg 合金の電解着色後の色調に及ぼす連続ねじり加工の影響
复制标题
连续扭转对铝镁合金阳极氧化着色后色调的影响
DOI：
10.2320/jinstmet.72.739
复制
发表时间：
2008
影响因子：
--
通讯作者：
正孝 増田
中科院分区：
文献类型：
--
作者：
悟 大上;博昭 中野;大輔 倉井;久哲 福島;克昭 中村;正孝 増田
在303 K的含Cu、Sn、Ni和Co的硫酸盐溶液中，对经连续旋转渐进控制（CREO）处理的Al-Mg合金进行了10 V的交流电解阳极氧化着色，阳极氧化后的Al-Mg合金分别呈现红褐色（Cu）、黄色至金色（Sn）和红褐色（Ni和Co）。着色铝镁合金的亮度显着提高CREO，无论金属沉积。铝镁合金的光泽度下降，可能是由于CREO导致的表面波纹度增加。着色铝镁合金经CREO处理后，其光亮度的提高主要是由于光泽度的降低。SEM照片显示，CREO使铝镁合金阳极氧化膜中的微孔密度降低。微孔密度的降低可以被认为增强了经CREO处理的着色Al-Mg合金的亮度。
Al-Mg alloys treated by continuous rotation evolutional control (CREO) were anodized and colored by means of AC electrolysis at 10 V in sulfate solutions of 303 K containing Cu, Sn, Ni or Co. The anodized Al-Mg alloys were colored rufous (Cu), yellow to gold (Sn), or red brown (Ni and Co) by the electrolysis. The lightness of the colored Al-Mg alloys was significantly enhanced by CREO, regardless of the metals deposited. The gloss of the Al-Mg alloys decreased-probably due to an increase in surface waviness resulting from CREO. The enhancement of the lightness of colored Al-Mg alloys treated by CREO is attributed to the decrease in the glossiness. SEM images showed that the density of the micro-pores in anodic oxide films on Al-Mg alloys decreased as a result of CREO. The decrease in the density of the micro-pores may be assumed to have enhanced the lightness of the colored Al-Mg alloys treated by CREO.
影响因子：
1.2
作者：
Katsuaki Nakamura;K. Neishi;K. Kaneko;M. Nakagaki;Z. Horita
通讯作者：
Katsuaki Nakamura;K. Neishi;K. Kaneko;M. Nakagaki;Z. Horita