SHEAR-RATE-DEPENDENCE MODELING OF POLYMER MELT VISCOSITY
SHEAR-RATE-DEPENDENCE MODELING OF POLYMER MELT VISCOSITY
复制标题
DOI：
10.1002/pen.760321404
复制
发表时间：
1992-07-01
影响因子：
3.2
通讯作者：
CHIANG, HH
中科院分区：
文献类型：
--
作者：
HIEBER, CA;CHIANG, HH
Steady-shear-viscosity data sets for commercial-grade acrylonitrile-butadiene-styrene terpolymer, nylon, polycarbonate, poly(methylmethacrylate), and polystyrene are fitted in terms of a generalized Cross/Carreau modeling for the shear-rate dependence. Based upon extensive data sets from the open literature as well as in-house measurements, it is shown that the shear-rate dependence can be more accurately described in terms of the Cross rather than Carreau model. Although the resulting viscosity fits based upon these two models might differ by 20% or more for the same well-characterized data set, the resulting effect upon simulating the injection-molding process is found to be much smaller since such predictions reflect a range of shear stresses (varying linearly from centerline to wall of cavity) over which the two models alternate in relative magnitude. This is demonstrated by detailed representative numerical predictions which are presented for both the filling and post-filling stages.
