Comparison of the Embodied Energy of a Grinding Wheel and an End Mill
Comparison of the Embodied Energy of a Grinding Wheel and an End Mill
复制标题
DOI：
10.1016/j.procir.2014.06.037
复制
发表时间：
2014
期刊：
影响因子：
--
通讯作者：
B. Kirsch;Christian Effgen;M. Büchel;J. Aurich
中科院分区：
文献类型：
--
作者：
B. Kirsch;Christian Effgen;M. Büchel;J. Aurich
本文介绍了一种新型硬质合金立铣刀和一种新型硬质合金立铣刀的工作原理和工作原理。这两种工具都是关于几何形状和组成的工业标准。分析和比较了两种工具制造的单个工艺步骤及其能量需求。此外，基于文献值，它们各自的磨损行为加工Inconel 718进行了比较。尽管与立铣刀相比，砂轮的包含能量高得多，但示出了加工特定体积的材料（J/mm 3）所需的包含能量对于砂轮而言是相当低的。
In this paper, measurement results of the embodied energy of a corundum grinding wheel and a coated cemented carbide end mill are presented. Both tools are industrial standard regarding geometry and composition. The single process steps and their energy demands for the manufacturing of both tools is analyzed and compared. In addition, based on literature values, their respective wear behavior machining Inconel 718 is compared. Despite a much higher embodied energy of the grinding wheel compared to the end mill, it is shown that the required embodied energy to machine a specific volume of material (J/mm3) is considerably lower for the grinding wheel.