Experimental investigations into effect of milling parameters on milling force and burr micromorphology for Zr-based bulk metallic glass by using groove milling
Experimental investigations into effect of milling parameters on milling force and burr micromorphology for Zr-based bulk metallic glass by using groove milling
复制标题
DOI：
10.1007/s00170-023-11062-4
复制
发表时间：
2023-02
期刊：
影响因子：
--
通讯作者：
Yin Liu;Y. Gong;Xiaoqing Cui;Zheng Liang;Weijun Liu;Z. Yuan;Heran Yang;Zhixu Dong;Xingwei Sun-Xi
中科院分区：
文献类型：
--
作者：
Yin Liu;Y. Gong;Xiaoqing Cui;Zheng Liang;Weijun Liu;Z. Yuan;Heran Yang;Zhixu Dong;Xingwei Sun-Xi
Zr-based bulk metallic glass is an amorphous alloy. In order to study the burr problem in the groove milling process of Zr-based bulk metallic glass, the milling force in the process is studied experimentally. Then the effect of milling parameters on the burr of Zr-based bulk metallic glass was studied, and the relationship between milling force and burr was analyzed. In order to further study the milling burr of amorphous alloy, under the same test parameters, the single crystal alloy material (nickel base single crystal superalloy DD5) and the traditional polycrystalline metal material (304 stainless steel) were selected for comparative test and analysis. The results show that Zr-based bulk metallic glass has good groove milling machinability. The test results provide some experimental basis for groove milling of Zr-based bulk metallic glass.
