Transient Interface Temperatures in Plain Peripheral Milling
Transient Interface Temperatures in Plain Peripheral Milling
复制标题
DOI：
10.1115/1.4012362
复制
发表时间：
1958-02
期刊：
影响因子：
--
通讯作者：
D. E. McFeron;B. Chao
中科院分区：
文献类型：
--
作者：
D. E. McFeron;B. Chao
将刀屑界面温度的解析计算推广到平面外围铣削过程中。所提出的方程的解使研究材料和工艺变量对基本切削数据的影响成为可能。研究发现，与单点车削相比，这种切削过程的间歇性增加了从刀具-切屑界面进入刀具的热流百分比。工件温度的轻微升高对刀具-切屑界面温度的影响比刀具温度的类似升高更为显著。
The analytical calculation of tool-chip interface temperature has been extended to the plain peripheral milling process. The solution of the equations presented enables an investigation of the effects of material and process variables to be made from fundamental cutting data. It was found that the intermittent nature of this cutting process increases the percentage of heat flow from the tool-chip interface into the tool as compared with single-point turning. A slight increase in the workpiece temperature has a more pronounced influence on the tool-chip interface temperature than would a similar increase in the tool temperature.