A Non-Contact-Type RF MEMS Switch for 24-GHz Radar Applications
A Non-Contact-Type RF MEMS Switch for 24-GHz Radar Applications
复制标题
DOI：
10.1109/jmems.2008.2011124
复制
发表时间：
2009-02-01
影响因子：
2.7
通讯作者：
Cho, Dong-il
中科院分区：
文献类型：
--
作者：
Park, Jachong;Shim, Eun Sub;Cho, Dong-il
This paper presents the design, fabrication, and measurement results for a novel non-contact-type radio-frequency (RF) microelectromechanical systems switch for 24-GHz radar applications. The proposed switches are free from unavoidable microwelding and stiction problems in other contact types, which in turn guarantee high reliability and long lifetime. The developed switch is a capacitive shunt type using a variation of the capacitance between the signal line and ground lines. The capacitance is precisely regulated by comb-drive actuators. This concept is simple, but the design requires a large and precise mechanical motion. In addition, for a low-loss switch structure, an air bridge with a large air gap is required. Therefore, the selective silicon-on-insulator process, based on the sacrificial bulk micromachining process, is designed for this switch fabrication. First, large insulating supports are fabricated 60 mu m below the wafer surface, and then, the RF switch is fabricated on these insulating supports. The measured actuation voltage is 25 V, and the actuation stroke is 25 mu m. The switching times are 8 ms in the OFF to the ON state and 200 mu s in the ON to the OFF state. In the RF characteristic measurements, the insertion loss without the long coplanar waveguide line loss is 0.29 dB and the isolation is 30.1 dB at 24 GHz. The bandwidth is relatively narrow, and the isolation is 25 dB or better in the range of 23.5-29 GHz. The reliability test for the switch was performed 10(9) times with 18-mW RF power. We observed no mechanical failure or RF performance degradation. A power handling capacity of 0.9 W with a hot-switch condition was achieved. [2007-0183]
