Material Removal Simulation for Abrasive Water Jet Milling
Material Removal Simulation for Abrasive Water Jet Milling
复制标题
磨料水射流铣削的材料去除模拟
DOI：
10.1016/j.procir.2017.12.110
复制
发表时间：
2018
期刊：
影响因子：
--
通讯作者：
M. Zeis
中科院分区：
文献类型：
--
作者：
F. Klocke;T. Schreiner;M. Schüler;M. Zeis
磨料水射流（AWJ）铣削，通常被称为磨料水射流铣削，已被证明是最灵活的非传统生产技术之一，难以加工的材料。目前，没有合适的材料去除模拟水射流铣削工艺。开发了AWJ控深加工过程的模块化材料去除仿真系统。由于材料去除量强烈地取决于编程刀具路径的每单位长度的能量输入，因此必须考虑编程进给速率的不期望偏差，如由水射流机床引入的锐角处的进给速率下降。
Abrasive water jet (AWJ) milling, often referred to as abrasive water jet milling, has proven to be one of the most flexible non-conventional production techniques for difficult-to-machine materials. Currently no suitable material removal simulation for the water jet milling process is available. A modularized material removal simulation for the AWJ controlled depth machining process has been developed. Because the volume of material removal strongly depends on energy input per unit length of programmed toolpath, undesired deviations of the programmed feed rate like feed rate drops at sharp corners introduced by the water jet machine tool must be considered.