A thermographic camera method for measuring the core loss distribution
A thermographic camera method for measuring the core loss distribution
复制标题
一种测量铁损分布的热像仪方法
DOI：
10.1016/j.jmmm.2020.166679
复制
发表时间：
2020
影响因子：
2.7
通讯作者：
S. Aihara
中科院分区：
文献类型：
--
作者：
H. Shimoji;T. Todaka;S. Aihara
电机铁芯损耗通常被评估为总损耗减去已知损耗，包括铜损耗和机械损耗。然而，这是很难确定的主要原因的核心损失的基础上，这种评估方法。在我们以前的研究中，我们提出了一种方法，直接评估铁损分布的基础上使用热成像相机的热量测量。在本文中，我们研究的可靠性，热测量使用的设备，可以同时测量磁芯损耗的一般磁性方法和热测量方法。在比较方法中，使用开放磁路单片测试仪同时进行磁损耗和热测量，该测试仪允许用热成像相机同时对样品进行直接成像，并且比较和检查铁损值。我们证明了一个很好的协议之间的热和磁测量低于10%的差异高于1T的磁通密度。
Motor core losses are usually evaluated as the total loss minus known losses, including copper and mechanical losses. However, it is difficult to identify the main cause of core losses based on this evaluation method. In our previous study, we proposed a method for directly evaluating core loss distribution based on heat measurements using a thermographic camera. In this paper, we examine the reliability of thermal measurements using a device that can simultaneously measure core loss both by the general magnetic method and by the thermal measurement method. In the comparison method, the magnetic loss and thermal measurements are conducted simultaneously using an open magnetic path single sheet tester that permits simultaneous direct imaging of a sample with a thermographic camera, and the core loss values are compared and examined. We demonstrate a good agreement between the thermal and magnetic measurement below 10% difference for flux densities higher than 1T.
使用热成像技术测量磁芯损耗分布
影响因子：
2.1
作者：
Hiroyasu Shimoji;Bartosz E.Borkowski;Takashi Todaka;Masato Enokizono
通讯作者：
Masato Enokizono