Joining aluminum to titanium alloy by friction stir lap welding with cutting pin
Joining aluminum to titanium alloy by friction stir lap welding with cutting pin
复制标题
通过切割销搅拌摩擦搭接焊将铝与钛合金连接起来
DOI：
10.1016/j.matchar.2012.05.013
复制
发表时间：
2012-09
影响因子：
4.7
通讯作者：
Syed Hamid Raza
中科院分区：
文献类型：
--
作者：
Yanni Wei;Jinglong Li;Jiangtao Xiong;Fu Huang;Fusheng Zhang;Syed Hamid Raza
采用搅拌摩擦焊对1060铝合金板和Ti-6Al-4V钛合金板进行搭接连接。采用硬质合金旋转锉的切削销。采用扫描电镜观察了连接界面的微观组织。通过拉伸剪切试验评价接头强度。在焊接过程中，钛板的表层被销钉切断，并与位于钛板上的铝充分混合。显微组织分析表明，界面处存在明显的漩涡状混合区。在该区域内，Al金属、Ti金属以及它们的混合层都存在。接头的拉伸剪切极限强度达到了1060铝合金的100%。
Aluminum 1060 and titanium alloy Ti–6Al–4V plates were lap joined by friction stir welding. A cutting pin of rotary burr made of tungsten carbide was employed. The microstructures of the joining interface were observed by scanning electron microscopy. Joint strength was evaluated by a tensile shear test. During the welding process, the surface layer of the titanium plate was cut off by the pin, and intensively mixed with aluminum situated on the titanium plate. The microstructures analysis showed that a visible swirl-like mixed region existed at the interface. In this region, the Al metal, Ti metal and the mixed layer of them were all presented. The ultimate tensile shear strength of joint reached 100% of 1060Al that underwent thermal cycle provided by the shoulder.
登录
查看更多内容
影响因子：
3.3
作者：
A. Fuji
通讯作者：
A. Fuji
影响因子：
6.2
作者：
Saeid, T.;Abdollah-zadeh, A.;Sazgari, B.
通讯作者：
Sazgari, B.
影响因子：
4.6
作者：
Kreimeyer, M;Wagner, F;Vollertsen, F
通讯作者：
Vollertsen, F
影响因子：
6.2
作者：
Abdollah-Zadeh, A.;Saeid, T.;Sazgari, B.
通讯作者：
Sazgari, B.
影响因子：
4.7
作者：
Hamilton, Carter;Dymek, Stanislaw;Blicharski, Marek
通讯作者：
Blicharski, Marek