Size Effects on Transferability and Mold Change of Glass Molding Press for Microgrooves
Size Effects on Transferability and Mold Change of Glass Molding Press for Microgrooves
复制标题
DOI：
10.4028/www.scientific.net/amr.497.235
复制
发表时间：
2012-04
期刊：
影响因子：
--
通讯作者：
Tianfeng Zhou;Jixin Yan;T. Kuriyagawa
中科院分区：
文献类型：
--
作者：
Tianfeng Zhou;Jixin Yan;T. Kuriyagawa
利用玻璃模压机（GMP）在玻璃表面加工出3种不同间距的微槽。实验研究了金刚石切削镍磷（Ni-P）镀层微槽的尺寸效应，并在此基础上，采用Ni-P模具进行GMP微槽加工。最后，对比了镍磷合金模具在GMP前和GMP后100次注射后的变化，并讨论了模具变化的尺寸效应。通过对不同间距微槽制作的对比研究，提出了一种制作更小尺寸微槽的方法。
Glass molding press (GMP) was applied to the fabrication of 3 kinds of microgrooves with different pitches on the glass surface. The size effects of microgroove fabrication on the Nickel Phosphorous (Ni-P) plating layer by diamond cutting were experimentally tested, and then, the size effects of microgroove fabrication by GMP using the Ni-P mold were experimentally tested. Finally, the changes of the Ni-P mold after GMP by 100 shots were compared with the microgroove mold before GMP, and the size effects of the mold change were discussed. By the comparison research of microgroove fabrication with different pitches, it suggests a way to create microgrooves with even smaller size.