In-situ processing of Al alloy composites
In-situ processing of Al alloy composites
复制标题
DOI：
10.1002/adem.200390027
复制
发表时间：
2003-03-01
影响因子：
3.6
通讯作者：
Reddy, RG
中科院分区：
文献类型：
--
作者：
Zheng, QJ;Wu, BQ;Reddy, RG
本文研究了采用气体鼓泡法原位加工非连续增强铝合金复合材料（DRAC）。细小的 SiC 和 AlN 颗粒分别通过含碳和含氮气体鼓泡来合成。这些结果表明，通过原位气体鼓泡途径加工 DRAC 在技术上是可行的。与传统的加工技术相比，该方法有可能以更低的成本生产出具有更好微观结构和性能的DRAC。
In-situ processing of discontinuously reinforced Al alloy composites (DRACs) by gas-bubbling method was investigated in this paper. Fine SiC and AlN particles were synthesized by bubbling C-bearing and N-bearing gases respectively. These results show that processing of DRACs through in-situ gas-bubbling route is technically feasible. Compared with conventional processing techniques, this method has the potential to produce DRACs with better microstructure and properties while with lower cost.