Cutting force model for gear honing
Cutting force model for gear honing
复制标题
DOI：
10.1016/j.cirp.2018.03.022
复制
发表时间：
2018-01-01
影响因子：
4.1
通讯作者：
Bergs, Thomas
中科院分区：
文献类型：
--
作者：
Bergs, Thomas
在齿轮研磨中，工艺的低稳健性是工艺设计中的一个挑战。加工产生的力与系统的动态行为相互作用，从而影响工件的质量和刀具寿命。由于这些原因，必须在局部和临时确定珩磨过程中的加工力。在此基础上，建立了相应的力模型，并对其进行了参数化模拟试验。将该力模型与珩齿加工过程模拟和速度分析计算相结合。通过试验对该模型进行了验证。(C)2018年由爱思唯尔有限公司代表CIRP出版。
In gear honing the low robustness of the process is a challenge in process design. The forces resulting from the machining interact with the dynamic behavior of the system which influences the quality of the workpiece and the tool life. Due to these reasons, the process forces during gear honing must be determined locally and temporally resolved. Therefore, a force model was derived and parameterized with gear honing analogy trials. This force model was combined with a process simulation for gear honing and an analytical calculation of the velocities. The model for gear honing was validated with gear honing trials. (C) 2018 Published by Elsevier Ltd on behalf of CIRP.