Analysis and fabrication for the dimensional expansion of arc 3D display to cone-shaped display
Analysis and fabrication for the dimensional expansion of arc 3D display to cone-shaped display
复制标题
DOI：
10.1007/s10043-022-00772-x
复制
发表时间：
2022-11
期刊：
影响因子：
1.2
通讯作者：
Akua Kawakami;Haruki Mizushina;S. Suyama;Kenji Yamamoto
中科院分区：
文献类型：
--
作者：
Akua Kawakami;Haruki Mizushina;S. Suyama;Kenji Yamamoto
本文成功地分析了三维图像在空气中的定位与锥形圆弧三维显示器上的弧形划痕之间的关系。弧形3D显示器通常是平面的，其分析已经出现。然而，当我们想要将其扩展到圆锥形状时，由于缺乏足够的分析会增加三维图像位置的近似误差，因此必须进行尺寸扩展分析。本文讨论了锥形圆弧三维显示的三维分析问题。此外，我们描述了实际制作的圆弧三维显示器，并表明三维图像可以显示类似的分析。
This paper successfully describes the analysis between 3D image location in air and arc-shaped scratches on cone-shaped arc 3D display. The arc 3D display is typically flat and its analysis has already appeared. However, when we would like to extend it to cone shape, the dimensional extension of analysis should be necessary, since the lack of adequate analysis increases the approximation error of the 3D image location. In this paper, we discuss the three-dimensional analysis for cone-shaped arc 3D display. In addition, we describe the actual fabrication of a cone-shaped arc 3D display and show that the 3D image can be displayed similarly with the analysis.