Study on Material Removal Mechanism in EDM Process through Observation of Resolidification of Molten Metal

Study on Material Removal Mechanism in EDM Process through Observation of Resolidification of Molten Metal
复制标题

DOI:
10.1016/j.procir.2017.12.060
复制
发表时间:
2018
期刊:
Procedia CIRP
影响因子:
--
通讯作者:
Shinya Hayakawa;Kazuaki Minoura;F. Itoigawa;Takashi Nakamura
Shinya Hayakawa;Kazuaki Minoura;F. Itoigawa;Takashi Nakamura
中科院分区:
其他
文献类型:
--
作者:
Shinya Hayakawa;Kazuaki Minoura;F. Itoigawa;Takashi Nakamura

文献摘要

被引文献

相似文献

为了研究电火花加工(EDM)过程中材料的去除机理,对金属液中材料的去除进行了观察。由于材料的去除不仅在放电过程中是间歇性的,而且在放电结束后也是间歇性的,因此对于后一种情况,我们假设熔融金属中溶解气体的脱气,即熔融金属再凝固时发生的脱气,是材料去除的可能机制之一。利用彩色高速摄像机,观察了薄钢板在焦耳加热作用下的熔化过程和冷却过程中材料的去除过程。根据视频图像中RGB信号强度的比值,测量了平板表面的温度分布。发现在常压空气中发生了物质的去除,而在真空中却没有发生。还发现,当局部温度低于材料的熔点时,材料的去除发生在某个位置。因此,观察到的材料去除机理被认为是熔融金属中溶解气体的脱气。
Material removal from molten metal was observed in order to investigate the material removal mechanism in the electrical discharge machining (EDM) process. Since material removal occurs intermittently not only during the discharge duration but also just after the discharge duration, we hypothesize for the latter case that degassing of the solution gas in the molten metal, which will occur when the molten metal resolidifies, is one of the possible mechanisms of material removal. A thin steel plate was melted by its own Joule heating and material removal occurring during the cooling process was observed using a color high-speed video camera. The temperature distribution on the plate surface was measured from the ratio of the intensities of RGB signals of the video image. It was found that material removal occurred in atmospheric pressure air, whereas it did not occur in vacuum. It was also found that the material removal occurred at a location when the local temperature fell below the melting point of the material. Therefore, the mechanism of the observed material removal was considered to be degassing of the solution gas in the molten metal.