Radio frequency measurements and tuning of the China Material Irradiation Facility RFQ

Radio frequency measurements and tuning of the China Material Irradiation Facility RFQ
复制标题

DOI：
10.1016/j.nima.2018.02.047
复制
发表时间：
2018-05
期刊：
Nuclear Instruments & Methods in Physics Research Section A-accelerators Spectrometers Detectors and Associated Equipment
影响因子：
1.4
通讯作者：
Chenxing Li;Yuan He;Feng-Feng Wang-Feng;Yu Peiyan;Lei Yang;C. G. Li;Wenbin Wang;Xianbo Xu;Longbo Shi;W. Ma;Liepeng Sun;L. Lu;Zhi-jun Wang;A. Shi;Tieshan Wang
Chenxing Li;Yuan He;Feng-Feng Wang-Feng;Yu Peiyan;Lei Yang;C. G. Li;Wenbin Wang;Xianbo Xu;Longbo Shi;W. Ma;Liepeng Sun;L. Lu;Zhi-jun Wang;A. Shi;Tieshan Wang
中科院分区：
物理与天体物理3区
文献类型：
--
作者：
Chenxing Li;Yuan He;Feng-Feng Wang-Feng;Yu Peiyan;Lei Yang;C. G. Li;Wenbin Wang;Xianbo Xu;Longbo Shi;W. Ma;Liepeng Sun;L. Lu;Zhi-jun Wang;A. Shi;Tieshan Wang

文献摘要

被引文献

相似文献

中国材料辐照装置RFQ的全面组装和对准工作已经完成。在完成之前，已经完成了单节段的组装和钎焊。对每个带有虚拟延伸底切的模块在钎焊前后进行了射频测量。结果表明，钎焊后无意外变形。在完成组装后，进行了射频测量和调谐，以补偿因制造、钎焊和组装而产生的误差。这些误差对场分布的影响被抑制到受束流动力学模拟限制的水平。本文阐述了射频测量和调谐的过程，给出了调谐后腔体的最终射频参数。
The full assembly and alignment of the China Material Irradiation Facility RFQ have been completed. Before the completion, the assembly and braze of single segments had been done. Radio frequency measurements of each module with dummy extension undercuts were performed before and after braze. The results reveal that there is no unexpected deformation after braze. After the full assembly, RF measurements and tuning have been performed in order to compensate the errors originated from the fabrication, braze and assembly. The impact of these errors on the field distribution is depressed to a level that is restricted by beam dynamics simulation. In this paper, the procedure of radio frequency measurement and tuning will be expatiated and the ultimate RF parameters of the cavity after tuning will be presented.