AC Winding Loss Reduction in High Speed Axial Flux Permanent Magnet Machines Using a Lamination Steel Sheet
AC Winding Loss Reduction in High Speed Axial Flux Permanent Magnet Machines Using a Lamination Steel Sheet
复制标题
使用叠片钢板降低高速轴向磁通永磁电机中的交流绕组损耗
DOI：
10.1109/iemdc.2019.8785086
复制
发表时间：
2019
期刊：
影响因子：
--
通讯作者：
G. Atkinson
中科院分区：
文献类型：
--
作者：
N. Aliyu;N. Ahmed;N. Stannard;G. Atkinson
本文研究了一种在单面开槽轴向磁通机（AFM）中使用软磁复合材料（SMC）铁芯和钢层压片屏蔽线圈杂散场的方法来降低交流铜损耗。这种方法很容易实现这种拓扑结构，不需要使用更复杂的扭曲和利茨型导体。为了提高性能，该机器在线圈和气隙之间放置了钢层压片，并使用3D有限元分析（FEA）进行了优化，以最大限度地减少线圈的交流损耗和层压涡流损耗。采用集中绕组。这些是预绕和滑动到开放，平行侧定子齿。这种施工方法确保了非常高的槽填充系数。通过实验验证了三维有限元模拟结果，表明该方法利用了层合板的屏蔽效应，降低了交流铜的损耗。结果表明，层压电导率越高，交流铜损耗越低，效率越高。
This paper examines a method of AC copper loss reduction in a single-sided open slotted Axial Flux Machine (AFM) using a Soft Magnetic Composite (SMC) core and a steel lamination sheet to shield the coils from stray fields. This approach is easy to implement for this topology and does not require the use of more complex twisted and Litz type conductors. To improve performance, the machine has a steel lamination sheet placed between the coils and airgap which has been optimized using 3D finite element analysis (FEA) to minimize both coil AC loss and lamination eddy current losses. Concentrated windings are used. These are pre-wound and slide onto the open, parallel sided stator tooth. This method of construction ensures a very high slot fill factor. The 3DFE simulations are validated with experimental tests and this paper shows the method has reduced AC copper loss by harnessing the shielding effect of the lamination sheet. It is found that the higher the conductivity of lamination, the lower the AC copper loss and better efficiency.
影响因子：
3.6
作者：
Ainslie, Mark D.;Rodriguez-Zermeno, Victor M.;Coombs, Timothy A.
通讯作者：
Coombs, Timothy A.