Removal of clofibric acid from aqueous solution by polyethylenimine-modified chitosan beads
Removal of clofibric acid from aqueous solution by polyethylenimine-modified chitosan beads
复制标题
DOI：
10.1007/s11783-013-0622-0
复制
发表时间：
2014-10-01
影响因子：
6.4
通讯作者：
Yu, Gang
中科院分区：
文献类型：
--
作者：
Nie, Yao;Deng, Shubo;Yu, Gang
Polyethylenimine (PEI)-modified chitosan was prepared and used to remove clofibric acid (CA) from aqueous solution. PEI was chemically grafted on the porous chitosan through a crosslinking reaction, and the effects of PEI concentration and reaction time in the preparation on the adsorption of clofibric acid were optimized. Scanning electron microscopy (SEM) showed that PEI macromolecules were uniformly grafted on the porous chitosan, and the analysis of pore size distribution indicated that more mesopores were formed due to the crosslinking of PEI molecules in the macropores of chitosan. The PEI-modified chitosan had fast adsorption for CA within the initial 5 h, while this adsorbent exhibited an adsorption capacity of 349 mg center dot g(-1) for CA at pH 5.0 according to the Langmuir fitting, higher than 213 mg center dot g(-1) on the porous chitosan. The CA adsorption on the PEI-modified chitosan was pH-dependent, and the maximum adsorption was achieved at pH 4.0. Based on the surface charge analysis and comparison of different pharmaceuticals adsorption, electrostatic interaction dominated the sorption of CA on the PEI-modified chitosan. The PEI-modified chitosan has a potential application for the removal of some anionic micropollutants from water or wastewater.
