Morphology and mechanical properties of injection molded poly(ethylene terephthalate)
Morphology and mechanical properties of injection molded poly(ethylene terephthalate)
复制标题
DOI：
10.1002/pen.20245
复制
发表时间：
2004-12
影响因子：
3.2
通讯作者：
Júlio C. Viana;N. M. Alves;J. Mano
中科院分区：
文献类型：
--
作者：
Júlio C. Viana;N. M. Alves;J. Mano
This work reports on the relationships between processing, the morphology and the mechanical properties of an injection molded poly(ethylene terephthalate), PET. Specimens were injection molded with different mold temperatures of 30°C, 50°C, 80°C, 100°C, 120°C, 150°C, while maintaining constant the other operative processing parameters. The thermomechanical environment imposed during processing was estimated by computer simulations of the mold-filling phase, which allow the calculation of two thermomechanical indices indicative of morphological development (degree of crystallinity and level of molecular orientation). The morphology of the moldings was characterized by differential scanning calorimetry (DSC) and by hot recoverable strain tests. The mechanical behavior was assessed in tensile testing at 5 mm/min and 23°C. A strong thermal and mechanical coupling is evidenced in the injection molding process, significantly influencing morphology development. An increase in the mold temperature induces a decrease of the level of molecular orientation (decrement in the hot recoverable strain) and an increment in the initial crystallinity of the moldings (decrement in the enthalpy of cold crystallization), also reflected in the variations of the computed thermomechanical indices. The initial modulus is mainly dependent upon the level of molecular orientation. The yield stress is influenced by both the degree of crystallinity and the level of molecular orientation of the moldings, but more significantly by the former. The strain at break was not satisfactorily linked directly to the initial morphological state because of the expected morphology changes occurring during deformation. Polym. Eng. Sci. 44:2174–2184, 2004. © 2004 Society of Plastics Engineers.
