Broadband down-conversion based near infrared quantum cutting in Eu2+–Yb3+ co-doped SrAl2O4 for crystalline silicon solar cells

Broadband down-conversion based near infrared quantum cutting in Eu2+–Yb3+ co-doped SrAl2O4 for crystalline silicon solar cells
复制标题

DOI:
10.1016/j.jssc.2015.02.020
复制
发表时间:
2015-03
影响因子:
3.3
通讯作者:
Y. Tai;Guojun Zheng;Hui Wang;J. Bai
Y. Tai;Guojun Zheng;Hui Wang;J. Bai
中科院分区:
化学3区
文献类型:
--
作者:
Y. Tai;Guojun Zheng;Hui Wang;J. Bai

文献摘要

被引文献

相似文献

在SrAl_2O_4:0.01Eu ~(2+),xYb ~(3+)(x=0,1,2,5,10,20,30mol%)样品中实现了近红外(NIR)量子剪裁,即从一个可见光吸收光子到两个近红外光子的发射。测量了样品在可见光和近红外区的光致发光特性,验证了Eu 2+向Yb 3+的能量转移。结果表明,Eu 2+是SrAl 2 O 4基质晶格中Yb 3+的有效敏化剂。通过高斯拟合分析和温度相关发光实验,得出协同能量转移(CET)过程占主导地位,Yb 3+的电荷转移态(CTS)的影响可以忽略不计的结论。结果表明,该体系具有较高的能量转移效率(埃特)和量子产率(QY),最大值分别达到73.68%和147.36%。因此,这种下转换材料在晶体硅太阳能电池中具有潜在的应用,以提高转换效率。
Near infrared (NIR) quantum cutting involving the down conversion of an absorbed visible photon to emission of two NIR photons was achieved in SrAl2O4:0.01Eu2+,xYb3+(x=0, 1, 2, 5, 10, 20, 30 mol%) samples. The photoluminescence properties of samples in visible and NIR regions were measured to verify the energy transfer (ET) from Eu2+to Yb3+. The results demonstrated that Eu2+was an efficient sensitizer for Yb3+in the SrAl2O4host lattice. According to Gaussian fitting analysis and temperature-dependent luminescence experiments, the conclusion was drawn that the cooperative energy transfer (CET) process dominated the ET process and the influence of charge transfer state (CTS) of Yb3+could be negligible. As a result, the high energy transfer efficiency (ETE) and quantum yield (QY) have been acquired, the maximum value approached 73.68% and 147.36%, respectively. Therefore, this down-conversion material has potential application in crystalline silicon solar cells to improve conversion efficiency.