Regular Folding Pattern Generation for Deployable Non-Axisymmetric Tubes
Regular Folding Pattern Generation for Deployable Non-Axisymmetric Tubes
复制标题
可展开非轴对称管的常规折叠图案生成
DOI：
--
复制
发表时间：
2014
期刊：
影响因子：
--
通讯作者：
I. Hagiwara
中科院分区：
文献类型：
--
作者：
Sachiko Ishida;T. Nojima;I. Hagiwara
在三种基本折叠设计的基础上，提出了两种基于规则排列折叠线的可展开非轴对称管的折叠模式建模方法；三浦折叠，风箱折叠，以及在每个节点有六条折线的折叠。第一种技术是允许从原始折叠模式中切割和去除不必要的部分-相应的直圆柱体之一。下一个技术是在不必要的部分上设计额外的折线，将它们折叠到管中，而不切割表面。因此，讨论和总结了各种折叠设计和建模技术的适用性和局限性。©2014 asme
This paper presents two modeling techniques to design folding patterns for deployable non-axisymmetric tubes, with regular arrangement of fold lines based on three fundamental folding designs; Miura folding, bellows folding, and folding with six fold lines at each node. The first technique is conducted by allowing cutting and removing unnecessary parts from the original folding pattern — one of the corresponding straight cylinder. The next technique is to design additional fold lines on unnecessary parts to fold them up into the tube, without cutting the surface. Consequently, applicability and constraints of each folding design and modeling techniques are discussed and summarized.© 2014 ASME