LIQUID INJECTION-MOLDING .1. INVESTIGATION OF IMPINGEMENT MIXING
LIQUID INJECTION-MOLDING .1. INVESTIGATION OF IMPINGEMENT MIXING
复制标题
DOI：
10.1002/pen.760170209
复制
发表时间：
1977-01-01
影响因子：
3.2
通讯作者：
SUH, NP
中科院分区：
文献类型：
--
作者：
MALGUARNERA, SC;SUH, NP
实验研究了冲击混合的流体力学，并建立了MIT液体注射成型系统的设计程序，包括放大。为了使冲击混合有效，基于喷嘴直径的雷诺数必须大于约50，并且流体组分的动量比必须等于1，此外还满足所需的质量流率比。
The fluid mechanics of impingement mixing was investigated experimentally, and the design procedure, including scale‐up, for the MIT Liquid Injection Molding System was established. For impingement mixing to be effective, the Reynolds number based on the nozzle diameter must be greater than about 50 and the momentum ratio of the fluid components must he equal to 1 in addition to satisfying the desired mass flow rate ratio.