Ring type Switched-Capacitor DC-AC Converter

对开关电容器低功耗的要求。SC)电源使用多个MOSFET开关以实现电路交换，建议采用n沟道MOSFET和较高的栅极驱动电压。第二个要求是启动电源中的深层次问题，因为启动电路的最后一级除了采用额外的启动电路外，不能利用电源以外的任何额外电压。为此，提出了一种电路结构简单的新型自举电路。此外，该电路还采用了省电模式，为栅极驱动器提供足够的电源电压。因此，采用所提出的栅极驱动器的DC-DC转换器在3.8V电源电压下的转换效率高达92%。提出的驱动电路最大限度地利用了环形SC电源。附加电路仅由多个开关和一个电容构成，节电模式能有效降低功耗。这将根据待机信号使所有时钟(驱动信号)处于非激活状态，从而使所有开关断开，并且输入/输出端子与电源和负载分离。这些实验结果和模拟结果在国际会议(ITC-CSCC 2002,2002年电路/系统、计算机和通信国际技术会议)上公布。对于移动设备显示器的背光，如小灵通，电致发光。(EL)被广泛要求。对于这种用途，非常小的SC电源是在一块芯片上试验性地生产的。裸片电源的尺寸为6.8 mm平方×3 mm厚，内置4个外部启动电容。目前由于沟道结构的制作方法限制了输出功率，但低噪声和极小尺寸的电源提供了光明的前景。

The requirement of the low power dissipation of switched-capacitor (abbr. SC) power supplies, which use many MOSFET switches for the performance of the circuit exchange, is recommended to adopt n-channel MOSFETs and a high gate-driving voltage. This second requirement is a deep problem in boot-up power supplies, because the last stage of boot-up circuits can not utilize any excess voltage than the power source except adopting an additional boot-up circuit. For this purpose, a novel boot-up circuit of simple circuit configuration is proposed. Furthermore, a power saving mode is adopted for this purpose.The proposed circuit provides sufficient power voltage to gate drivers. Therefore the DC-DC converter using the proposed gate driver gives a high conversion efficiency of 92% under the power source voltage of 3.8V. The proposed driving circuit is shown to make the best use of a ring-type SC power supply. The additional circuit is constructed only by several switches and one capacitor.The power-saving mode can reduce the power consumption effectively. This performs to make all clocks (driving signals) inactive according to the standby signal active, therefore the all switches turn off and the input/output terminals are separate from the power source and the load. These experimental results and simulation results are presented at the international conference (ITC-CSCC 2002, The 2002 International Technical Conference on Circuits/Systems, Computers and Communications).For backlighting of mobile equipment displays such as PHS, electroluminescent (abbr. EL) is extensively requested. For this usage, very small SC power supplies are experimentally produced on a chip. A size of the bare-chip power supplies is 6.8mm square×3mm thickness within 4 external boot-up capacitors. The output power is limited at the present time by the manufacturing method of the channel structure, but the low noise and extremely small size power supplies gave a bright vista.