The FE-I4 telescope for particle tracking in testbeam experiments
The FE-I4 telescope for particle tracking in testbeam experiments
复制标题
用于测试光束实验中粒子跟踪的 FE-I4 望远镜
DOI：
10.1088/1748-0221/11/07/p07003
复制
发表时间：
2016
影响因子：
1.3
通讯作者：
A. Sciuccati
中科院分区：
文献类型：
--
作者：
M. Benoit;J. Mendizabal;F. D. Bello;D. Ferrere;T. Golling;S. Gonzalez;G. Iacobucci;M. Kocián;D. Muenstermann;B. Ristic;A. Sciuccati
基于Atlas IBL硅像素模块的Testbeam望远镜已建立，它包括六个带有250×50μm2螺距的平面硅传感器，由Atlas Fe-i4芯片读取。 π+）在测试的设备位置上的分辨率高于8×12μm2主要用于使用基于FE-I4的原型的研究，但也可以通过独立的DAQ系统成功运行。第一个和最后一个像素传感器平面。湿度传感器和可移动阶段。
A testbeam telescope, based on ATLAS IBL silicon pixel modules, has been built. It comprises six planes of planar silicon sensors with 250 × 50 μ m2 pitch, read out by ATLAS FE-I4 chips. In the CERN SPS H8 beamline (180 GeV π+) a resolution of better than 8 × 12 μm2 at the position of the device under test was achieved. The telescope reached a trigger rate of 6 kHz with two measured devices. It is mainly designed for studies using FE-I4 based prototypes, but has also been successfully run with independent DAQ systems. Specialised trigger schemes ensure data synchronisation between these external devices and the telescope. A region-of-interest trigger can be formed by setting masks on the first and the last pixel sensor planes. The setup infrastructure provides centrally controlled and monitored high and low voltage power supplies, silicon oil cooling, temperature and humidity sensors and movable stages.
2015 年 180 nm AMS 高压 CMOS 传感器原型测试光束的结果
影响因子：
1.3
作者：
Benoit M
通讯作者：
Benoit M