Engineering Design Graphics Laboratory

本项目使用带有高级建模的Autocad Release 11 在80386 DX级计算机上执行的扩展， 6 MB RAM，80387数学协处理器，14”VGA 640-480 PIXIL 图形显示器，80兆硬盘驱动器，33兆赫的速度 高速缓存 输入/输出是使用 数字化仪/激光喷墨打印机。 使用这些工具时， 教学设计可视化和设计沟通。 的 实体模型三维数据库允许引入质量 工程设计图的属性分析 当然了 此外，这个数据库在分析中的价值， 制造、施工和设计文件， 讨论和演示。 Barr-Juricic模型 现代工程设计制图课程如下 工程设计图形（EDG） 课程现代化项目：一份白色论文摘要， 美国国家科学基金会现代化研讨会上提出的 工程设计制图课程。

This project uses Autocad Release 11 with Advanced Modeling Extension executed on 80386 DX class computers equipped with six megabyte RAM, 80387 math coprocessor, 14" VGA 640-480 PIXIL graphics monitor, 80 megabyte hard disk drive, and 33 mhz speed with cache memory. Input/output is accomplished using a digitizer / laser jet printer. These tools are used while teaching design visualization and design communication. The solid model 3-D database allows the introduction of mass properties analysis into the Engineering Design Graphics course. Also, the value of this database in analysis, manufacturing and construction and design documentation is discussed and demonstrated. The Barr-Juricic model of the modern Engineering Design Graphics course is followed as outlined in the paper, The Engineering Design Graphics (EDG) Curriculum Modernization Project: A White Paper Summary, presented at the NSF Symposium on modernization of the Engineering Design Graphics Curriculum.