study of the clinical application of the adhesive restorative materials
study of the clinical application of the adhesive restorative materials
批准号:
08407062
负责人:
TAGAMI Junji
金额:
$13.31万
依托单位国家:
日本
项目类别:
Grant-in-Aid for Scientific Research (A)
财政年份:
1996
资助国家:
日本
项目状态:
已结题
起止时间:
1996 至 1998
中文摘要
点击翻译按钮获取中文摘要
英文摘要
1. Bond strength to affected dentinIt was revealed that bond strengths of some resin bonding systems to several types of dentin surfaces affected by cervical abrasion, caries and laser irradiation showed lower bonds than those of normal dentin.2. Dynamic 3-D analysis of etched dentin surfacesTopography of wet and dried etched dentin surface was observed under a laser scanning microscope. Dentin surface etched with phosphoric acid showed shrinkage after air drying. The method that prevents shrinkage of etched collagen is ideal for sufficient penetration into demineralized dentin layer.3. Re-evaluation for the bonding performance to enamelIt was indicated that etching depth of phosphoric acid was 40 times greater than that of self etching primer. Thus, it was suggested that multiple application of self etching primer in the clinical situation. And, it was confirmed that the bond strengths to intact enamel surfaces were lower than those to ground enamel surfaces.4. SEM observation of bond … More ing interfacesThere was no correlation between the thickness of the hybrid layer and tensile bond strength. It can be considered that the mechanical properties of hybrid layer is more accessible to bond strength than its thickness.5. Clinical factors influencing dentin bondingIt was demonstrated that clinical factors (e.g. temperature, humidity, residues of temporary filling materials and endodontic treatment) influence the bond strengths of adhesive resin systems and resin luting cements to dentin.6. Bonding performance of composite resin inlaysThe bond strength of resin composite inlay to dentin was lower than that of resin composite for direct restoration. However, the bond strength indicated higher value when resin coating method was used.Consequently, it was proved that the properties of hybrid layer and bond strength varied because of the difference of composition and structure of dentin and several clinical factors. More research will be needed to confirm the optimal restorative procedures. Less
期刊论文(29)
专著(0)
科研奖励(0)
会议论文
登录
查看更多内容
Nobuharu Kanemura et al.: "Tensile Bond Strength and SEM Evaluation to Ground and Intact Enamel Surfaces" Journal of Dentistry. in press. (1999)
Nobuharu Kanemura 等人:“磨削和完整牙釉质表面的拉伸粘合强度和 SEM 评估”牙科杂志。
DOI:
--
发表时间:
期刊:
影响因子:
--
作者:
[]
通讯作者:
Miwako Ogata et al.: "Effect of application of dentin primer on regional bond strength to cervical wedge-shaped cavity walls." Operative Dentistry. (in press). (1999)
Miwako Ogata 等人:“牙本质底漆的应用对宫颈楔形腔壁区域粘合强度的影响。”
DOI:
--
发表时间:
期刊:
影响因子:
--
作者:
[]
通讯作者:
H.Nishida,et al.: "Dentin Pulp Complex" Quintessence Dublishing Co.,Ltd., 2 (1996)
H.Nishida 等:“牙本质浆复合体”Quintessence Dublishing Co.,Ltd., 2 (1996)
DOI:
--
发表时间:
期刊:
影响因子:
--
作者:
[]
通讯作者:
T.Nikaido et al.: "Shear bond strength of a single-step bonding system to enamel and dentin." Dintal Materials Journal. 16・1. 40-47 (1997)
T. Nikaido 等人:“牙釉质和牙本质单步粘合系统的剪切粘合强度”,Dintal Materials Journal 16・1 (1997)。
DOI:
--
发表时间:
期刊:
影响因子:
--
作者:
[]
通讯作者:
浦部 功ら: "走査型レーザー顕微鏡と走査電子顕微鏡によるエナメル質ならびに象牙質酸処理面の観察" 接着歯学. 15・1. 48-53 (1997)
Isao Urabe 等人:“使用扫描激光显微镜和扫描电子显微镜观察牙釉质和酸处理的牙本质表面”粘合剂牙科 15・1(1997 年)。
DOI:
--
发表时间:
期刊:
影响因子:
--
作者:
[]
通讯作者:
共 27 条
Application of optical coherence tomography in restorative dentistry
-
批准号:23390432
-
项目类别:Grant-in-Aid for Scientific Research (B)
-
资助金额:$12.31万
-
财政年份:2011
-
负责人:TAGAMI Junji
-
依托单位:
Caries activity assessment using the micro pH sensor and Real time PCR for cariogenic organisms obtained from the lowest pH area of caries dentin
-
批准号:17390507
-
项目类别:Grant-in-Aid for Scientific Research (B)
-
资助金额:$10.39万
-
财政年份:2005
-
负责人:TAGAMI Junji
-
依托单位:
Development of Micro pH Sensor for Diagnosis of Dental Caries Activity
-
批准号:14207079
-
项目类别:Grant-in-Aid for Scientific Research (A)
-
资助金额:$26.79万
-
财政年份:2002
-
负责人:TAGAMI Junji
-
依托单位:
A study on the microstructure of resin-dentin interface
-
批准号:02404074
-
项目类别:Grant-in-Aid for General Scientific Research (A)
-
资助金额:$8.7万
-
财政年份:1990
-
负责人:TAGAMI Junji
-
依托单位: