Integrated materials and processes modeling for design and process optimisation of an aircraft landing gear component

用于飞机起落架部件设计和工艺优化的集成材料和工艺建模

• 批准号: 445737-2012
• 负责人: Gakwaya, Augustin
• 金额: $ 6.38万
• 依托单位: Université Laval
• 依托单位国家: 加拿大
• 项目类别: Collaborative Research and Development Grants
• 财政年份: 2016
• 资助国家: 加拿大
• 起止时间: 2016-01-01 至 2017-12-31
• 项目状态: 已结题
• 来源: https://www.nserc-crsng.gc.ca/ase-oro/Details-Detailles_eng.asp?id=597041
• 关键词: Integrated; materials; processes; modeling; design

The aerospace industry is often at the leading edge of materials and processes technologies. Structural components have to meet high resistance requirements, while still being lightweight. Part design is thus of critical importance. Unfortunately, lacking knowledge about the behavior of the materials during forming, designers often rely on norms that may be too conservative or even worse, not well suited to the case of the part and material that they are working on, leading to defects in the final part.

航空航天工业通常处于材料和工艺技术的前沿。结构部件必须满足高阻力要求，同时仍然是轻量化的。因此，零件设计是至关重要的。不幸的是，由于缺乏对成形过程中材料行为的了解，设计师往往依赖于可能过于保守甚至更糟的规范，这些规范不太适合他们正在研究的零件和材料的情况，从而导致最终零件的缺陷。